Home > Products > Helmets > Kirby Morgan 37

Kirby Morgan 37

Body: 

KM37 Top Tab

Kirby Morgan® 37

see the difference

Configurations

  • 500-050 KM 37 Helmet w/Posts
  • 500-051 KM 37 Helmet w/MWPC

Standard Color

Color Options

(hover over to view color options)


km37_tabber

  • Manual KM37 & KM57
    This is your operations and maintenance manual. It is a writable USB flash drive which enables you to add or subtract the manual PDF sections as they are updated or when you purchase new Kirby Morgan products.
  • Logbook w/ pen
  • Over Pressure Relief Valve

    The Kirby Morgan® Overpressure Relief Valve is factory adjusted to vent any time the pressure in the low pressure hose connecting the bailout bottle to your emergency valve exceeds 200 P.S.I. It is installed in any of the low pressure ports in the first stage regulator.

  • SuperFlow First Stage, No Hose
  • Helmet/Mask Bag

    Measurements: 16’’ length x 12’’ width x 16’’ height. Made of high quality, tough black nylon, encasing a light weight, white polyethylene foam that features low water absorption and is fairly rigid (good impact strength). The two grommeted ventilation holes seen in the photo are on both sides of the bag. A large elastic topped pocket is on each side, for holding tool kits, checklists, logbooks, spares, etc. (There are no inside pockets). The bag handles are 1” wide straps of black polyester webbing. The bag closes up with two, large YKK zippers. We do not recommend the 500-901 helmet bag as a shipping container or packaging for your Kirby Morgan life support equipment!

  • Restrictor Adapter

    The 555-210 Restrictor Adapter should be used when an inflation hose is attached to the side block when drysuit diving. The main purpose of the Restrictor Adapter is to limit gas flow in the event the hose ruptures or is severed, and to ensure the loss of supply would not be great enough to significantly affect the diver’s breathing at moderate to heavy work rates. It also helps prevent filling the dry suit too rapidly.


    NOTE: O-ring 310-003 is required to install the Restrictor Adaptor onto the side block.