Updated with front stand offs.
Updated the layout, diagrams and cross references due to splitting the INTRO module into four separate modules.
Updated, "The SuperFlow® 350 regulator assembly" diagram to reflect the correct order of the clamp.
Changed step 5 in 1.1.3 Post Dive Reassembly to: Place whisker clamps around the grooves in each of the two whiskers. Before doing the final tightening of the whisker clamps, make sure that the parting line on the bottom of the wings is lined up with the parting line on the main body. For the SL 27 helmet ONLY, make sure that the parting line on the bottom of the whisker wings is 5/16" behind the parting line on the main body. Changed step 21 in 1.7 Reassembly of the SuperFlow® 350 Demand Regulator to: Place whisker clamps around the grooves on each of the two whiskers. Before doing the final tightening of the whisker clamps, make sure that the parting line on the bottom of the wings is lined up with the parting line on the main body. For the SL 27 helmet ONLY, make sure that the parting line on the bottom of the whisker wings is 5/16" behind the parting line on the main body. Changed the caption in step 24 1.7 Reassembly of the SuperFlow® 350 Demand Regulator to: The port and starboard whiskers should align with the whisker covering the main body so that the parting lines are in alignment (except in the SL 27 helmet, where the parting lines on the bottom of the whiskers should be 5/16" behind the mold line on the main body). You can also make marks on the whiskers with a felt tip pen.
Document #190625006 Original code for CE Mark.
Updated the material of the 510-776 exhaust valve.
Updated tools required on page SF350-13 and steps 24 and 25 on page SF350-19 in section 1.7 Reassembly of the SuperFlow® 350 Demand Regulator.
Updated the cross references to the torque specs due to the splitting of APNDX into three separate modules.
Updated the regulator mount nut removal image in section 1.3.1 SuperFlow® 350 Demand Regulator Removal from Helmet or Mask. Added the new note icons throughout the module. Added step seven about the regulator cover to section 1.5 Inspection of SuperFlow® 350 Demand Regulator Parts.
On page SF350-20 of the SuperFlow® 350 module section 1.7.1 Tuning the SuperFlow® 350 Regulator, changed step three to read: Pressurize the regulator to between 135-150 p.s.i.g. of supply pressure.
Updated layout.
